Skip to Content

I have a marble floor that I have to grind, hone and polish the edges with a hand machine. Every time I do this I seem to be getting soaking wet due to all the water I need to use. Is there a way to do this with less water?

Estimated Reading Time: < 1 Minute

The reason you require all the water is because your machine is too fast. Slow the machine down to the same speed as your floor buffer and you will require a lot less water. If your machine is not equipped with variable speed you can purchase a rheostat that can regulate the speed.

TIP Instead of using the water feed option on your machine, you can use a spray bottle. If your machine is slowed down you will not need as much water.

I have a marble floor that I have to grind, hone and polish the edges with a hand machine. Every time I do this I seem to be getting soaking wet due to all the water I need to use. Is there a way to do this with less water?