Q. How would I get rid of calcium buildup on a headstone? The primary surface is polished and where the engraving is it is rough. The calcium from the hard water has caused a buildup, especially in the rough area. What should I use to get the... Read More

Suppose you have an interior granite wall that had some silicon caulking used in the grout joints. The silicon then caused staining along the grout edges. A poultice successfully removed the staining, but then later, the stains reappeared. What... Read More

Q. We have mold buildup in grout joints and surface has film on it. What is best to clean mold and remove film from surface?   A. There are several cleaners that will remove the mold but you must be careful to choose one that will not damage the... Read More

What You Need to Know About Silicon Impregnator Removal When it comes to silicon impregnator removal, the results will vary depending on what type of surface the impregnator was applied to, how long it has been there, and what methods you are using... Read More

A string mop is preferable to a sponge mop. A sponge mop has a very small surface area, and can easily pick up sand and debris which will scratch the floor. It has been shown that after several swipes with a sponge mop, you are only spreading the... Read More

Depending on which machine you use the more weight the better. If your using a single disc machine use at least 75 pounds. It is important that your machine operate properly with the added weight. For this reason make sure you operate at least a 1 ½... Read More

The larger, heavier machines are much faster at grinding, honing and polishing granite. The large Italian grinders work well but many companies do not have access to them. Many of them also require 220 volts which can be difficult to get in certain... Read More

It is possible, but very time consuming. In question #120 we figure it would take about 15 minutes per square feet to restore an average granite floor. In the case of flamed granite it may take this long just to grind the tile flat. If the flamed... Read More

Pricing granite work is very difficult and will vary from region to region. At the time of this writing, I have seen prices as low as $7.00 per square foot to as much as $30.00 per square foot. The size of the job, the type of granite etc. are all... Read More

If these scratch patterns are what I think they are then they probably occurred during fabrication. Some polishing machines have ten inch diameter polishing heads. It is not unusual to have these patterns show up after the floor has been polished.... Read More